4-32. 4-33. 4-34. 4-35. 4-36. 4-37. Which of the following factors should NOT be included in project specifications? 1. Quality  of  materials 2. Workmanship standards 3. Crew  sizes 4. Description  of  materials The project supervisor should take which of the following actions when conflicts occur between the project drawings  and  the  specification? 1. Comply with the drawings 2. Comply with the specifications 3. Obtain guidance from S-3 4. Obtain guidance from the ROICC A contractor desiring to bid on a government construction project should  find  specific  bidding requirements  in  what  division of the project specifications? 1. 1 2. 10 3. 3 4. 13 The quality of all lumber to be used in a project is specified under what division of project specifications? 1. 10 2. 8 3. 6 4. 4 What division of the project specifications  will  normally specify the gauge of metal to be used for HVAC ductwork? 1. 5 2. 7 3. 13 4. 15 The type of materials used in a plumbing system should be specified in what part of the division dealing with plumbing? 1. 1 2. 2 3. 3 4-38. 4-39. 4-40. 4-41. 4-42. The specified fastening method for ceiling installation of gypsum wallboard should be identified in what part of the Finishes division of the project specifications? 1. 1 2. 2 3. 3 To save time and effort, you should make reference to NAVFAC and EFD guide specifications in the project specs. This is a common and accepted  practice  of  spec  writers. 1. True 2. False Learning  Objective: Define terminology  and  describe  technigues used  in  material  estimating. Which of the following qualities is required  to  be  a  good  estimator? 1. Sound  construction  knowledge 2. Knowledge  of  material estimating   procedures 3. Knowledge  of  material estimating   pitfalls 4. Each of the above When a conflict exists between the general  drawing  and  a  detail,  which drawing,  if  either,  should  you follow? 1. General  always 2. Detail  unless  it  is  obviously wrong 3. Detail  always 4. Neither,  contact  the  drafter What step should the estimator do first  when  starting  an  estimate? 1. Review  the  drawings 2. Read  NAVFAC  P-405 3. Study  the  specifications 4. Make a rough estimate from the  drawings 25