Ramsey and Sleeper, Architectural Graphic Standards, 7th ed., J. Wiley &
Sons, Inc., New York, 1981.
Chapter 8
Graphic Symbols for Plumbing Fixtures for Diagrams Used in Architecture
and Building Construction, ANSI Y32.4-1977, American Society of Mechanical
Engineers, New York, 1977.
U.S. Department of Defense, Mechanica/Symbols, MIL-STD-17B-1, Defense
Supply Agency, Alexandria, Va., 1963.
Utilitiesman 3, NAVEDTRA 10663, Naval Education and Training Program
Management Support Activity, Pensacola, Fla., 1988.
Chapter 9
Construction Electrician 3 & 2, NAVEDTRA 10636-H1, Naval Education and
Training Program Development Center, Pensacola, Fla., 1976.
Dagostino, F. R., Mechanical and Electrical Systems in Construction and
Architecture, Reston Publishing Company, Inc., Reston, Va., 1978.
Graphic Symbols for Electric Wiring and Layout Diagrams Used in
Architecture and Building Construction, ANSI Y32.9, Institute of Electrical
and Electronics Engineers, New York, 1972.
Planning Guide, Vol. 1, NAVFAC P-437, Naval Facilities Engineering
Command, Alexandria, Va., 1988.
U.S. Department of Defense, Construction Drafting, TM 5-581-B,
Headquarters, Department of the Army, Washington, D.C., 1972.
Chapter 10
Dimensioning and Tolerancing, ANSI Y14. 5M-1982, The American Society
of Mechanical Engineers, New York, 1982.
Drawing Sheet Size and Format, ANSI Y14.1-1980, The American Society
of Mechanical Engineers, New York, 1980.
U.S. Department of Defense, Construction Drafting, TM 5-581-B,
Headquarters, Department of the Army, Washington, D.C., 1972.
U.S. Department of Defense, Engineering Drawing Practices, DoD-STD-100C,
U.S. Army Armament Research and Development Command, Dover, N. J.,
1978.
U.S. Department of Defense, Policy and Procedures for Definitive and
Standard Design and Standard Specification Preparation, MIL-HDBK-1006/4,
Washington, D.C., 1987.
U.S. Department of Defense, Policy and Procedures for Project Drawing and
Specification Preparation,
MIL-HDBK-1006/1, Chesapeake Division,
Chesapeake, Va., 1987.
AVI-3
