IN  ANSWERING  QUESTIONS  4-40  THROUGH  4-43, SELECT THE CHARACTERISTIC FROM THE FOLLOWING LIST THAT IDENTIFIES OR APPLIES TO THE AUXILIARY  VIEW  GIVEN  AS  THE  QUESTION. A. PROJECTED FROM THE FRONT VIEW B. PROJECTED FROM A SIDE VIEW C. PROJECTED FROM THE TOP VIEW 4-40. Front. 1.   A 2.   B 3.   C 4-41. Right side. 1.   A 2.   B 3.   C 4-42. Elevation. 1.   A 2.   B 3.   c 4-43. Left side. 1.   A 2.   B 3.   C IN  ANSWERING  QUESTIONS  4-44  AND  4-45,  REFER TO FIGURE 5-25 IN THE TEXTBOOK. 4-44. 4-45. 4-46. The rear auxiliary view could also have been projected from which of the following  views? 1. Top 2. Front 3. Rear 4. Left  side The line BD appears in its true length in the rear auxiliary view and in what other view, if any? 1. The right side 2. The top 3. The  front 4. None What type of section view gives a complete cross-sectional view of an object? 1. Complete section 2. Full  section 3. Full plane section 4. Plane  section 4-47. 4-48. 4-49. 4-50. 4-51. 4-52. In half-sectioning a cylinder, how far should you extend the cutting plane? 1. Half the diameter of the cylinder 2. Half the radius of the cylinder 3. Half the circumference of the cylinder 4. A quarter of the circumference of the cylinder A section consisting of less than a half-section is referred to as what type of section? 1. Partial 2. Detail 3. Offset 4. Quarter At what angle from the horizontal should diagonal hatching be drawn an orthographic projection? 1. 15° 2. 30° 3. 45° 4. 60° in In an isometric drawing, what is the angle that each line of the axis forms  with  the  adjacent  line? 1. 45° 2. 60° 3. 90° 4. 120° In  an  isometric  projection,  the object is inclined to conform with which of the following characteristics? 1. All surfaces make the same angle with the plane of projection 2. The face makes an angle of 30° with the plane of projection 3. The face makes an angle of 60° with the plane of projection 4. Each edge forms an angle of 45° with the plane of projection Which of the following descriptions most accurately applies to the of projection in an isometric drawing? 1. Converging 2. Diverging 3. Parallel to the plane of projection 4. Perpendicular to the plane projection lines of 27