1-52.
1-53.
In steel building construction,
what type of connector is used
more that any other type?
1.
Weld
2.
Bolt
3.
Pin
4.
Rivet
When bolts are used, how does the
hole size compare to the nominal
bolt size?
1.
Half-size larger
2.
Same size
3.
Slightly smaller
4.
Slightly larger
Figure 1B
IN ANSWERING QUESTIONS 1-54 THROUGH 1-56,
REFER TO FIGURE 1B.
1-54.
What type and size of weld is
to be made on the “other side”?
1.
1/4-inch bevel weld
2.
1/4-inch vee weld
3.
1/2-inch fillet weld
4.
1/2-inch bevel weld
1-55.
What does the numeral 4 mean?
1.
The length of the weld
in inches
2.
The length of the weld
in millimeter
For structural steework, rivets
are manufactured from what type
3.
The center-to-center spacing
of the weld in inches
4.
The center-to-center spacing
of the weld in millimeters
1-56.
1-57.
1-58.
1-59.
1-60.
What does the small flag shown
in the symbol indicate?
1.
The “other side” weld only
is to be made in the shop
2.
The “arrow side” weld only
is to be made in the field
3.
Both the “other side” and
“arrow side” welds are to
be made in the shop
4.
Both the “other side” and
“arrow side” welds are to
be made in the field
When a reference is not required,
what part of a welding symbol can
be omitted?
1.
The arrow
2.
The reference line
3.
The tail
4.
The detail reference symbol
For structural work, the diameter
of rivets most often used are
1.
1
and 1 1/4 inches
2.
3/4 and
7/8 inch
3.
1/2 and
5/8 inch
4.
1/4 and
3/8 inch
For a 1-inch-diameter rivet, what
size hole should be drilled?
1.
2.
3.
4.
1
inch
1 1/16 inches
1 3/16 inches
1 1/4 inches
of material?
1.
Iron
2.
Hard steel
3.
Soft steel
4.
Aluminum
7
